PROLiNK PHC105 User Manual - Manual (Page 10)

PROLiNK® PHC-105 User’s Manual www.prolink2u.com
Version 1.00 5 English
CHAPTER 3 DEFINE THE USER
3.1 User Authorization Level
 There are two levels, each with a different password and authorization level, namely Administrator and
Operators. Both authorities are realized by password.
 Default password for operators is 1234, for administrator is 5678.
 Furthermore, the camera can preset one alarm number to receive alarm. Every time the camera sends alarm,
the alarm number will receive.
User Type
Function
Administrator Operators Alarm number
Receive alarm No No Yes
Listen to the monitoring area No Yes No
Set alarm number, E-mail address, time, MMS
parameters, data account
No Yes No
Arm/Disarm the camera No Yes No
Check status, receive images by mobile phone
or E-mail
No Yes No
Set alarm-mode No Yes No
Change password Yes No No
Reset the camera Yes No No
Table 3.1 the difference in authority for users:
Note:
1. Any MMS enabled mobile phone can receive the images captured by the camera by sending SMS command with password.
2. Any SMS enabled mobile phone can control the camera with the password command.
3. Any WCDMA supported mobile phone can check on-spot video with the password command.
All the settings of the camera can be set or adjusted via a SMS command.
About the SMS command:
1. All the SMS commands are composed with password and words; password must be input before the words for
each command. Different passwords have different authority. (See Appendix: SMS command list).
2. Administrator and operator users’ SMS command format: password commands
3. The password must be a four-digit number.
4. The original password for operators is 1234, while for administrator is 5678.
5. The maximum digits that are allows for the phone number is 16.
6. The camera will reply to the user after it receives the SMS command.
Note:
For SMS commands, between not only password and word but also word and word must have one space character.