Bosch DWB129950 Diseño Box EAN 4242002490267 Ancho 120 cm - Manual (Page 32)

32
4. Place flue ducts on the extractor hood, push
the inner flue duct upwards and attach the
left and right sides to the fixing bracket.
5. Screw the inner flue duct with 2 screws to
the sides of the fixing bracket.
Installing the flue ducts
ṇ
RISK OF INJURY
The insides of the flue ducts may have sharp
edges. We recommend wearing protective
gloves during installation.
1. Separate the flue ducts. To do this, remove
the adhesive tape.
2. Remove the protective film from both flue
ducts.
3. Insert one flue duct into the other.
NOTE: Avoid scratching the flue ducts when
inserting them, e.g. by placing the installation
template as protection over the edge of the outer
flue duct.
Note the position of the slots in the flue
duct!
– Exhaust-air mode: Slots of the inner flue
duct downwards.
– Circulating-air mode: Slots of the inner flue
duct upwards.
Installation