ABC Office Finisher 4300 - Manual (Page 11)

X. Trouble-shooting...
Symptom Possible Cause Corrective Action
LCDs do not show display No power to laminator Close panel breaker
when heat switches are on.
Blown fuse Disconnect power and
replace fuse
Film is not bonding to the print Laminator not set to optimal Adjust temperature slightly
laminating temperature upward.
Ink on print is wet Allow ink to dry thoroughly
Paper is too slick Use a more matte paper
Laminated item curls Top or bottom film tension Loosen tension on side (top
is too high or bottom) that is curling up
Laminated item is wrinkled Mandrel tension too loose Increase mandrel tension on
side (top or bottom) that has
wrinkles
Temperature too high Reduce temperature
Moisture in paper being laminated Store paper in dry area
Laminated item is blistered Temperature too high Reduce temperature
Mandrel tension does not remain Brake nut improperly adjusted Tighten nut
constant
Core gripper blade is not preventing Rotate film core while
holding the mandrel
the core from spinning on the firm to lock the
mandrel blade into the core.
Mandrels are reversed. Reverse mandrels
9
abcoffice
800-658-8788 www.abcoffice.com