Bosch TASSIMO T12 TAS1202 - Manual (Page 7)

55 en
Problem Cause Solution
The brewing unit cannot
be opened. The brewing unit is still
locked. Wait until the Status LED 3 has stopped
blinking before attempting to open the
brewing unit.
If the brewing unit stays locked, contact the
TASSIMO careline.
Fill water tank 2
lights up. There is not enough water in
the water tank. Fill the tank with cold, fresh water as far as
the max mark. Reinsert the water tank.
Fill water tank 2 lights
up even though there
is enough water in the
water tank. The float in the water tank
is stuck. Clean the water tank and free the float.
The water tank is not
inserted correctly. Check that the water tank has been
correctly inserted.
Descale 1 lights up or
starts to flash. The appliance needs to be
descaled. Descale the appliance. Please refer here to
the section f Descaling.
Descale 1 lights up
or starts flashing even
though decalcified water
has been used. Even decalcified water
contains low amounts of
calcium carbonate. Descale the appliance. Please refer here to
the section f Descaling.
Where can I obtain
descaling agents? Special descaling agents can be obtained
from www.tassimo.com, the Bosch
customer service department (article no.
573828, for contact details, see page 29) or
from your retailer.
The quality of the crema
has deteriorated. The beverage outlet is sticky
or dirty. Clean the beverage outlet. Please refer here
to the section e Cleaning.
Clean the brewing unit with the yellow
Service T DISC. Please refer here to the
section e Cleaning.
Build-up of limescale in the
appliance. Descale the appliance. Please refer here to
the section f Descaling.
Water is dripping from
the brewing unit. The T DISC is damaged or
leaky.
The T DISC has not been
pierced correctly. Do not use T DISCs more than once.
Do not use damaged T DISCs.
Wait until the brewing stage has come to
an end and the appliance has cooled down.
Remove the T DISC and clean the brewing
unit. Please refer here to the section
e
Cleaning.
The piercing unit has not
been inserted correctly. Press the piercing unit into its holder using
both thumbs (until an audible click is
heard).
Troubleshooting
H
TAS12xx_1Text_UC.indb 5 26.04.2013 14:34:31