Addonics Technologies MINI STORAGE TOWER NA3MS4HU2B - Manual (Page 2)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
Removing Cover of Mini
Storage Tower
Loosen the 3 screws at the back of the tower
using a Philips screwdriver by turning
counter-clockwise. Separate the metal
casing of the tower from the housing by lifting
up the casing as shown on the photo.
Installing drives into the
Storage Tower
Step 1
Slide the storage device into the embedded
mounting bracket.
Step 2
Using 3.5” SATA Hard Disk Drives - Connect
the internal SATA data cable to the data port
of the hard drive then connect the 15-pin
SATA power connector to the power port on
the hard drive.
Step 3
Secure the hard disk by using screws
provided. Repeat the above procedure for
additional hard drives.
Setting RAID on the Hardware Port Multiplier (HPM)
Hard Disk
LED Pins
Pin 1
SATA Port 3
SATA Port 2
SATA Port 1
SATA Port 4
- +
- +
- +
- +
- +
- +
- +
- + eSATA Status
USB Status
PM Power
PM Health
HD3 PWR & Access
HD2 PWR & Access
HD1 PWR & Access
HD0 PWR & Access