Server PUMPS (88521/88200 ) - Manual (Page 3)

CLEAN INSIDE
DISCHARGE TUBE
CLEAN INSIDE
TAPERED END
OF DISCHARGE TUBE
PUMP ASSEMBLY PUMP ASSEMBLY
ALWAYS CLEAN PUMP THOROUGHLY BEFORE EACH USE
AND AFTER USE DAILY. SEE PUMP DISASSEMBLY AND
PUMP CLEANING.
1 INSTALL SEAL O-RING INSIDE SEAL.
• Apply food equipment lubricant on seal o-ring.
2 INSTALL SEAL SECURELY ONTO HEAD ASSEMBLY
PISTON.
• Apply food equipment lubricant inside seal.
• Flared end of seal assembly should be facing away
from piston head.
• If seal is installed incorrectly, product will leak past
seal.
3 APPLY A SMALL AMOUNT OF FOOD EQUIPMENT
LUBRICANT INSIDE BOTTOM OF HEAD ASSEMBLY
PISTON. THEN INSTALL PINCH VALVE INTO BOTTOM
END OF HEAD ASSEMBLY PISTON.
• Rotate pinch valve inside head assembly piston
to spread lubricant evenly inside end of head
assembly piston. Then position pinch valve
securely into a sealed position on end of head
assembly piston.
4 INSTALL GAGING COLLAR ONTO SIDE OF HEAD
ASSEMBLY PISTON.
5 INSTALL SPRING INTO CYLINDER.
6 INSTALL CAP BY SECURELY SNAPPING IT ONTO
CYLINDER, PAST THREADING.
7 SECURE CAP TO BOTTLE OR INSTALL LID BY SLIDING
LID UP FROM BOTTOM OF CYLINDER TO ALIGN
WITH CAP. SECURE PUMP TO BOTTLE OR LID BY
TIGHTENING CAP TO BOTTLE OR LID THREADING.
8 APPLY A SMALL AMOUNT OF FOOD EQUIPMENT
LUBRICANT INSIDE TOP OF CYLINDER AND TO
OUTSIDE SURFACE OF SEAL.
9 INSTALL HEAD ASSEMBLY PISTON INTO CYLINDER.
J SLIDE LOCKING COLLAR DOWN ONTO CYLINDER
THREADING AND TIGHTEN TO SECURE HEAD
ASSEMBLY TO CYLINDER.
K PREPARE PUMP FOR USE.
• Operate pump several times until only product,
without air bubbles, is delivered with each stroke
of pump.