Adcom ACE-615 - Manual (Page 3)

Operation
The unswitched front panel LED e indicates that AC
current is passing through the ACE-615 and into the
components connected to the unswitched AC rear
panel outlets
1) . The unswitched LED e is always on
provided the unit is plugged into an active AC source.
To prevent turn-on thump, the jacks for the accessories
and amplifiers have seperate relays. When the ACE-615 is
turned on, the accessories power up before the amplifiers.
When powering down, the relay works in reverse. These
delays are in effect both with the 12V trigger source, and
without, and the duration may be adjusted by your autho-
rized ADCOM dealer.
power 120v 60Hz
max 1800W
12v trigger
in
GND
WARNING: For indoor use in dry locations only.
To reduce the risk of shock, do not expose this unit
to rain or moisture.
10 Timber Lane
Marlboro, NJ 07746 USA
Made in the USA
Surge Protector and AC Enhancer model ACE-615
voltage: 120V AC/60Hz, internal power consumption: 10w max
max 1500W
serial #
max 300W
amplifiers (switched 10 sec delay on turn-on) unswitched accessories (switched 30 sec delay on turn-off)
WARNING: Equipment with high-current requirements, such as hobby arc-welders, hair
dryers and heaters must not be plugged into these AC receptacles. Never allow total power
consumption of all equipment connected to these outlets to exceed 1800 watts.
in out
coax 1
in out
coax 2
in out
phone 1
phone 2
P
RE
SS TO RES
ET
CI
RC
UIT BREAKE
R
circuit breaker
15A
Front Panel Control
Press the ACE-615 power button b to activate the unit.
The power LED b , accessories LED c , and amplifiers
LED d will glow red. AC power is being supplied to all
connected components.
Remote 12v Trigger Control
* Note: This section only applies when an external trigger is
connected to the 12v trigger in jack 1@ .
* Note: The unit only responds to an external trigger when the
power button b is pressed in. The power button b can
be used to override the 12v trigger input and turn the
ACE-615 off.
Press the ACE-615 power button b to put the unit
into standby mode. The power LED b will glow amber
to device
from wall
to device from wall
to preamp
to AC outlet television laser disc player compact disc player D
VD pla
y
er
preamp vcr amplifier two amplifier one
indicating it is waiting for an external 12v trigger to power
on. Turn on the component supplying the 12v trigger. The
ACE-615 power button LED
b and switched LED c and
amplifiers LED d will glow red indicating AC power is
being supplied to all connected components. Turn off
the 12v trigger supply to return the ACE-615 to
standby mode.
Typical Connections