Electro Cam PS-6000 Series - Manual (Page 5)

PS-6000 Series with -MSV Option
Description
The -MSV (Master-Slave) option allows up to four controllers
to be daisy-chained to one resolver. Controllers with the -MSV
option are equipped with a jumper that the user can plug/un-
plug to configure the unit to be either a master or a slave. The
controller comes from the factory jumpered as a master, but
can be set to slave status by removing the jumper.
Figure 3
shows jumper location:
The wiring of the resolver is daisy-chained to all of the control-
lers as shown below in
Figures 4 & 5. The master controller
supplies the reference signal to the resolver and slave units.
The resolver supplies the position information to all units. Only
a single unit can be the master. Daisy-chain the power from
controller to controller in the same way as the resolver signals.
Connect one of the controllers directly to the power supply.
Power for the other devices in the system should come directly
from the power supply. DO NOT power other devices from the
wires powering the controllers. This will help reduce the risk of
problems associated with EMI and ground loops. Use the stan-
dard resolver cable from master to resolver. Use a PS-5300-
05-XXX resolver cable from the master to slave controllers, and
from slave to slave.
NOTE: PS-6344 Series Controllers include Master-Slave
feature as standard.
All other features of the -MSV version of 6000 series con-
trollers are the same as those for standard PS-6000 series
controllers.
Figure 3
Figure 4
Figure 5
5