Electronics International CA-1 - Manual (Page 21)

18
Remote Switch Wiring Diagram
To Instrument EGT or CHT Channel.
(For a twin unit, to Instrument Left or Right Channel)
To Cyl. #1.
To Cyl. #2.
To Cyl. #3.
To Cyl. #4.
To Cyl. #5 (RS-6 only).
To Cyl. #6 (RS-6 only)
"Wht/Violet and
Wht/Gray" Pair
"Brown" Pair
"Red Stripe" Pair
"Orange" Pair
"Yellow" Pair
"Green" Pair
"Blue" Pair
RS-4-1, RS-4-2, RS-6-1 and RS-6-2
Remote Switch
Back Panel
RS-4-2 and RS-6-2 Only
From the back of the RS-6-2 and RS-4-2 there are two groups of the above wires. Connect one group to the
EGT Probes (or left channel for a twin installation) and connect the other group to the CHT (or right
channel for a twin installation).