Elite Screens Starling Tension Series User Manual
Page 5
V022814-JA
www.elitescreens.com
5
3. Extended IR sensor: Plug the extended IR sensor into the port located on the left side of the screen’s
lower part next to the weight bar. (see below image for precise port location)
4. 5-12 volt trigger: Connect the mini jack plug end to the 5-12 volt trigger port (see image above) and the
other end to your projector’s output port to synchronize the projector’s power cycle to your screen.
Connection to the projector’s trigger port is not included. Refer to the diagram below for wiring
instructions. Contact your projector’s manufacturer for proper 5-12 volt trigger cable information.
The screen should automatically DROP when the projector is turned ON and RETRACT when the projector
is turned OFF. You can test the operation using a 9-volt battery.
5. UP/DOWN manual control buttons (located on left side end cap)
For a local Elite Screens contact or Technical Support, please
visi
Extended IR sensor port
5-12 v trigger port
Press and hold the UP button to retract the screen
Press and hold the Down button to deploy the screen
Front side of screen