Elite Screens ezFrame Plus Series - Manual (Page 4)

4
Rev.091912-JA
www.elitescreens.com [email protected]
Tension Rod (Horizontal) x 4
Tension Rod (Vertical) x 2
Tension Rod (horizontal)
Push
Tension Rod (Vertical)
Attaching the screen material to the frame
1. Lay out the screen and tension rods on a clean and dry surface. Insert the screen tension rods through the
sleeves according to their corresponding lengths on each edge of the screen as shown below. (see fig.4)
2. Place the screen material on the back of the built frame and slip the tension rods into the grooves running along
each side on the back of the frame on all four corners and insert the fix plates to the back of the frame’s grooves to
secure the rods in to place creating tension for a tight and flat surface. (see fig. 5 & fig. 6)
Steel rod
Push
( fig.4)
Steel rod
Screen
Push
Rod
Rod
Tension Rod (fig. 5) (fig. 6)