Emergi-Lite Mini Revelation Battery Series - Manual

Emergi-Lite
Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com
MINI Retract-Lite: Concealed Emergency Lighting
1/4
08/08 750.1322 Rev. B
MINI Retract-Lite: Concealed Emergency Lighting
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
6. Do not use this equipment for other than intended use.
7. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions (Figure 1)
The emergency lighting unit comes with a U-shaped metal bracket, for
rigid mounting on wall studs and ceiling joists covered by drywall. This
bracket can be installed (retrofit) after the drywall is put in. For installa-
tion, the cable(s) for AC power supply (and DC remote) must be passed
near a wall stud or ceiling joist.
“U” Bracket Installation in the wall (Figures 2a, b, c)
1. Cut a rectangular opening (8-1/4 inch by 5-3/4 inch) in the drywall
next to the wall stud. The opening must have the short side along the
stud. Use the "U" bracket to mark the dimensions on the drywall.
2. Pass the electrical cable(s) out through the hole.
3. Slide the “U” bracket in the hole: enter the flange side first then push
the other side to the stud.
4. Fix the “U” bracket on the stud with appropriate fasteners (not sup-
plied).
5. Check that the four mounting screws are turned 2-3 threads in the
pem-studs.
IMPORTANT: If the electrical cables pass in the wall from the ceiling,
make sure they are long enough to go out at least 3 to 4 feet through
the rectangular hole. This will ensure the flexible cables will loop and
access the bottom of the equipment about 1 ½ feet below the rectangular
hole.
Figure 1
Figure 2a
Figure 2b
8-1/4”
5-3/4”
“Mini”
Unit
Equipment
“ U” Bracket