Emergi-Lite Provider PRO-2N/PRO-3N Series - Manual

Emergi-Lite
Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com 02/14 750.1705 Rev. C
Provider Series - Emergency lighting
1/2
Use flexible
conduit only
Provider Series -
Emergency lighting
6 volt
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. All servicing should be performed by qualified service personnel.
2. Do not use outdoors.
3. Do not let power supply cords touch hot surfaces.
4. Do not mount near gas or electric heaters.
5. Use caution when handling batteries. Avoid possible shorting.
6. Equipment should be mounted in locations and at heights where it will not
readily be subjected to tampering by unauthorized personnel.
7. The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
8. Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2.
Route AC unswitched circuit of rated voltage into junction box and leave 6" of
wire length.
3. Remove the backplate by pressing on the tabs (see fig. 2) with a screw-
driver.
4. Locate the AC connector (if applicable) and attach to the AC circuit (or to the
line cord for units with such an option). Refer to step 7.
5. Determine the desired position of the test switch (see fig. 5) before mounting
the backplate.
6. Choose the proper mounting solution below and continue to step 7.
NOTE: For units with a safety wire, install the safety wire (see figure 1), after install-
ing the back plate, as a means to support the unit while making connections. Insert
one of the screws, used for fixing the backplate to the mounting surface or junction
box, through the lug on the end of the safety wire before screwing it in place.
Important: all AC or DC connections must be done in individual external
junction boxes.
a. Junction box mounting
Knock out the proper hole pattern in the back cover to mount to a standard
junction box. Route the AC supply leads or connector through the large
knockout and mount the backplate to the junction box (see fig. 3a).
b. Ceiling mount
Caution! DO NOT install unit to the ceiling unless its model number
includes the suffix "CM".
For installation instructions refer to the addendum for ceiling mount.
c. Flexible conduit entry mounting
For conduit entry, mount the backplate to the wall. Break out the conduit
hole on the housing (see fig. 3c). Assemble the conduit to the backplate.
WARNING:
Risk of Shock.
Disconnect Power before Installation.
Figure 1
1
2
3
4
5
6
Parts List
1. Backplate
2. Housing
3. Clear lens
4. Safety wire (not available
for all units)
5. Securement screw(ceiling
mount)
6. AC connector (not avail-
able for all units)
Figure 2
Tabs
Pry here, under the cover,
with a screwdriver
Junction box mounting Line cord installation
(optional)
Figure 3a Figure 3b
Strain
Pre-drilled hole for line cord
relief
Conduit hole
to knock out
Figure 3c