Emergi-Lite KS Steel Series - Manual

Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com 04/03 750.0031 Rev. J
KS Series – Emergency Lighting Unit
1/2
KS Series – Emergency Lighting Unit
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not let power supply cords touch hot surfaces.
2. Do not mount near gas or electric heaters.
3. Use caution when handling batteries. Avoid possible shorting.
4. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
6. Caution: If optional Halogen cycle lamp(s), symbol (H—), are used in
this equipment, to avoid shattering: do not operate lamp in excess of
rated voltage, protect lamp against abrasion and scratches and
against liquids when lamp is operating, dispose of lamp with care.
7. Halogen cycle lamps operate at high temperatures. Do not store or
place flammable materials near lamp.
8. Do not use this equipment for other than intended use.
9. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Route AC circuit wires from electrical box and leave 12” of wire
length.
Note — A weather tight fitting for cord connection is supplied, how-
ever, if conduit entry is desired, weather tight conduit fittings such as
RACO 3400 Series or other UL recognized equivalent must be used.
Caution — Be sure to drill hole for conduit fitting in marked location
below vent or where it will not interfere with circuit board or battery.
3. Remove four screws on door. Open door and lift door from hinges.
4. For units above 54W: Remove batteries for ease of installation.
5. Remove the two screws securing the battery bracket and retain.
6. Remove the battery bracket and retain.
7. Remove the battery assembly.
8. Disconnect two lamp connectors. For units with AD option, discon-
nect the ribbon cable from display board in door.
Note — Select proper input wire and insu-
late unused transformer lead.
White (neutral)
Black (120)
Orange (277)
To DC
lamps
Battery
Figure 1