Emergi-Lite Premier Series - Exit Sign - Manual

Emergi-Lite
Tel: (888) 552-6467 Fax: (800) 316-4515 www.emergi-lite.com 11/09 750.1372 Rev. B
Premier Series - Thermoplastic LED Exit Sign
1/2
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
taken including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufacturer
may cause an unsafe condition.
6. Do not use this equipment for other than intended use.
7. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Route AC unswitched circuit of rated voltage into electrical box and leave
6” of wire length.
3. Remove the exit door using a coin or a screwdriver at the top or bottom
of the door.
4. Determine the mounting position (end, wall or ceiling). Note: canopy is
required for end or ceiling mount.
5. Our system can accept input voltages of 120 VAC or 277 VAC. There-
fore, connect the black (120 VAC) or orange (277 VAC) and white (com-
mon) leads to the building utility. Connect the Green wire to the ground.
Unused primary wire must be insulated to prevent shorting
Wall mounting
a. No canopy required. With the help of a flat head screwdriver, knock
out the proper hole pattern in the back cover to mount to a standard
junction box (See Fig. 2). Feed the AC supply leads out through the
center hole and make the proper connections. Feed the excess wire
into the junction box and secure the back cover to the junction box
using the junction box screws. Proceed to step 6.
End or ceiling mount
a. Canopy required. Attach the spider plate to electrical box with the
junction box screws. Remove appropriate hole plug. Feed AC supply
leads through side or top opening and then through canopy. Snap
canopy on top or side of frame (See Fig. 3). Screw canopy to
frame(11). In the case where a canopy lock is supplied, you may
refrain from screwing the canopy to the frame and simply snap the
Figure 1
Premier Series - Thermoplastic LED Exit Sign
AC, AC/DC or Self-Powered
Figure 3
Figure 2
FLAT HEAD SCREWDRIVER
KNOCK OUT
GROOVE
CANOPY HOUSING SCREW
Part List
1. Back plate
2. Frame
3. Diffuser panel
4. Exit door
5. Hole plug for Canopy
6. Canopy
7. Junction box screws (not
provided)
8. Spider plate
9. Junction box
10. Canopy plate screw
11. Canopy housing screw
12. Canopy lock