Emergi-Lite Literay Series - Manual

Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com 09/05 750.1198 Rev. A
Literay TM – Installation instructions
1/1
Emergi-Lite Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com 09/05 750.1198 Rev. A
1/1
Literay TM – Installation instructions
Installation instructions
1. Fasten the mounting braket to the junction box using the
two screws provided. The threaded nipple should be facing
the outward direction.
2. Make the proper connections. The fixture is made for 6 or
12 VDC (see lamp voltage on marking). Connect the lamp
wires to de DC supply wires.
3. Place the fixture against the mounting surface allowing the
threaded nipple to pass through the fixture back plate.
Secure with the lock nut and the cap nut provided.
4. Install the light bulb(s) Caution. Refer to the relamping
label located near the lamp holder or the recommended
maximum wattage. Do not exceed recommended wattage.
5. Secure the lens and decorative cover to the fixture with the
screws provided.
6. Turn on DC power and check the operation of your lighting
fixture.
Adjusting the lamps
The head can be adjusted in two ways: by rotating it, and by
tilting it.
Rotation: To rotate the heads, hold it and turn it either sides.
Tilt: To tilt the head, hold it and tilt upwards or downwards.
Part List
1. Cover screws (3)
2. Decorative cover
3. Lens
4. Back plate
5. Lamp ass'y (2)
6. Wire way grommet 7. Cap nut
8. Lock nut
9. Threaded nipple
10. Junction box screws (2)
11. Mounting bracket
12. Jonction Box (not provided)
Figure 1
Installation instructions
1. Fasten the mounting braket to the junction box using the
two screws provided. The threaded nipple should be facing
the outward direction.
2. Make the proper connections. The fixture is made for 6 or
12 VDC (see lamp voltage on marking). Connect the lamp
wires to de DC supply wires.
3. Place the fixture against the mounting surface allowing the
threaded nipple to pass through the fixture back plate.
Secure with the lock nut and the cap nut provided.
4. Install the light bulb(s) Caution. Refer to the relamping
label located near the lamp holder or the recommended
maximum wattage. Do not exceed recommended wattage.
5. Secure the lens and decorative cover to the fixture with the
screws provided.
6. Turn on DC power and check the operation of your lighting
fixture.
Adjusting the lamps
The head can be adjusted in two ways: by rotating it, and by
tilting it.
Rotation: To rotate the heads, hold it and turn it either sides.
Tilt: To tilt the head, hold it and tilt upwards or downwards.
Part List
1. Cover screws (3)
2. Decorative cover
3. Lens
4. Back plate
5. Lamp ass'y (2)
6. Wire way grommet 7. Cap nut
8. Lock nut
9. Threaded nipple
10. Junction box screws (2)
11. Mounting bracket
12. Jonction Box (not provided)
Figure 1