Information, Repeat play, Displaying the text – Alpine CDE-121 User Manual

Page 23

Advertising
background image

22

-EN

01GB04CDE121.fm

ALPINE CDE-121 68-16909Z79-A (EN)

Repeat Play

Only Repeat One is available for the iPod/iPhone.

Repeat One:

A single song is repeatedly played back.

1

Press

4.

The song is played back repeatedly.

2

To cancel repeat play, select (off) with the
above procedure.

During repeat playback, no other songs are selectable by

pressing

or .

Displaying the Text

You can display the tag information of a song in the iPod/
iPhone.

Press VIEW.

Each press changes the display.

When the TEXT SCR is set to SCR MANU, press and

hold VIEW for at least 2 seconds, the current text will be
scrolled one time.

* TAG information

“ARTIST”/“ALBUM”/“SONG” is displayed if there is
no tag information.

Only alphanumeric characters (ASCII) can be displayed.
If the artist, album or song name, created in iTunes, has

too many characters, songs may not be played back
when connected to the adapter. Therefore, a maximum of
250 characters is recommended. The maximum number
of characters for the head unit is 70 (70 byte).

Some characters may not be correctly displayed.
“NO SUPPORT” is displayed if text information is not

supported by the unit.

In Case of Difficulty

If you encounter a problem, please turn the power off, then
on again. If the unit is still not functioning normally, please
review the items in the following checklist. This guide will
help you isolate the problem if the unit is at fault.
Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.

No function or display.
• Vehicle’s ignition is off.

- If connected following instructions, the unit will not

operate with the vehicle’s ignition off.

• Improper power lead (Red) and battery lead (Yellow)

connections.
- Check power lead and battery lead connections.

• Blown fuse.

- Check the fuse of the unit; replace with the proper

value if necessary.

Unable to receive stations.
• No antenna or open connection in cable.

- Make sure the antenna is properly connected; replace

the antenna or cable if necessary.

Unable to tune stations in the seek mode.
• You are in a weak signal area.

- Make sure the tuner is in the DX mode.

• If the area you are in is a primary signal area, the antenna

may not be grounded and connected properly.
- Check your antenna connections; make sure the

antenna is properly grounded at its mounting location.

• The antenna may not be the proper length.

- Make sure the antenna is fully extended; if broken,

replace the antenna with a new one.

Broadcast is noisy.
• The antenna is not the proper length.

- Extend the antenna fully; replace it if it is broken.

• The antenna is poorly grounded.

- Make sure the antenna is grounded properly at its

mounting location.

(Repeat
One)

TRACK NO./ELAPSED TIME

TRACK NO./CLOCK

ARTIST NAME*

ALBUM NAME*

SONG TITLE*

TRACK NO./ELAPSED TIME

(off)

Information

Basic

Radio

01GB00CDE121.book Page 22 Monday, December 13, 2010 2:03 PM

Advertising
This manual is related to the following products: