AEG LAVAMAT 40820 - Manual (Page 24)

User’s instructions
24
The washing cycle is much
too long : • the water inlet is blocked,
• there was a power supply failure or the
water was cut off,
• the motor temperature safety device
tripped,
• the water inlet temperature is lower
than normal.
Softener or Javel* water
flows through the over-
flow orifice when filling : • you did not put in the right amount,
• the siphons at the back of the deter-
gents dispenser are blocked.
*Depending on the model
Symptom Cause