Bosch KGN49VW20 Frigo-congelatore da libero posizionamento Bianco - Manual (Page 38)

en
38
Fault Possible cause Remedial action
Controls have reduced
luminosity.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Displays do not illuminate. Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Connect mains plug. Check whether the power
is on, check the fuses.
Warning signal sounds.
The alarm button is lit.
Fig. "/2
Fault – the freezer
compartment is too warm!
To switch off the warning signal, press
the alarm button 2.
Appliance is open. Close the appliance.
Ventilation openings have
been covered.
Ensure that there is adequate ventilation.
Too much food was placed in
the freezer compartment at
once.
Do not exceed max. freezing capacity.
When the fault has been eliminated, the alarm
button goes out shortly afterwards.