Alamo 66 - Manual (Page 43)

MAINTENANCE
Maintenance Section 5-5
© 2005 Alamo Group Inc.
GRIZZLY 66 01/05
Dry Bolt 375 ft/lb
w/ Red Locktite Appplied 282 ft/lb
BIKON TORQUE VALUES
(TABLE 1)
FIGURE 1
BIKON TORQUING SEQUENCE
*
PROPER TORQUE FOR FASTENERS
The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to this
chart to determine the grade of bolts and the proper torque except when specific torque values are assigned in
manual text.
RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL*
NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine oil.
They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are used.
This applies to both UNF fine and UNC coarse threads.
(TABLE 2)