Earthway Flex-Select Broadcast Matrix - Metric - Manual

GRANULAR MATERIAL
PARTICLE SIZES: Fine/Small  Medium  Large  EXTRA LARGE 
(SAND) (HALF BB) (BB) ROCK SALT
SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD
SETTING WIDTH FT METERS SETTING WIDTH FT METERS SETTING WIDTH FT METERS SETTING WIDTH FT METERS
5 7 18 5.5 9 24 7.3 14 36 11.0 17 37 11.3
10 10 18 5.5 13 24 7.3 18 36 11.0 22 37 11.3
15 13 18 5.5 16 24 7.3 23 36 11.0 24 37 11.3
20 14 18 5.5 20 24 7.3 27 36 11.0 26 37 11.3
24 16 18 5.5 22 24 7.3 30 36 11.0 28 37 11.3
29 18 18 5.5 25 24 7.3 23 x 2 pass 36 11.0 29 37 11.3
34 20 18 5.5 27 24 7.3 25 x 2 pass 36 11.0 30 37 11.3
39 22 18 5.5 28 24 7.3 27 x 2 pass 36 11.0 26 x 2 pass 37 11.3
44 24 18 5.5 30 24 7.3 28 x 2 pass 36 11.0 27 x 2 pass 37 11.3
49 26 18 5.5 22 x 2 pass 24 7.3 30 x 2 pass 36 11.0 28 x 2 pass 37 11.3
GRASS SEED
FINE SPREAD SPREAD COARSE SPREAD SPREAD
SETTING WIDTH FT METERS SETTING WIDTH FT METERS
10 14 8 2.4 22 14 4.3
15 16 8 2.4 25 14 4.3
20 18 8 2.4 28 14 4.3
25 20 8 2.4 30 14 4.3
GRANULAR MATERIAL
PARTICLE SIZES: Fine/Small  Medium  Large  EXTRA LARGE 
(SAND) (HALF BB) (BB) ROCK SALT
SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD
SETTING WIDTH FT METERS SETTING WIDTH FT METERS SETTING WIDTH FT METERS SETTING WIDTH FT METERS
5 8 16 4.9 10 20 6.1 15 30 9.1 18 24 7.3
10 10 16 4.9 13 20 6.1 18 30 9.1 20 24 7.3
15 12 16 4.9 18 20 6.1 23 30 9.1 25 24 7.3
20 13 16 4.9 20 20 6.1 28 30 9.1 27 24 7.3
24 16 16 4.9 22 20 6.1 30 30 9.1 30 24 7.3
29 18 16 4.9 25 20 6.1 23 x 2 pass 30 9.1 25 x 2 pass 24 7.3
34 20 16 4.9 27 20 6.1 25 x 2 pass 30 9.1 26 x 2 pass 24 7.3
39 21 16 4.9 29 20 6.1 28 x 2 pass 30 9.1 27 x 2 pass 24 7.3
44 23 16 4.9 30 20 6.1 29 x 2 pass 30 9.1 29 x 2 pass 24 7.3
49 24 16 4.9 22 x 2 pass 20 6.1 30 x 2 pass 30 9.1 30 x 2 pass 24 7.3
GRASS SEED
FINE SPREAD SPREAD COARSE SPREAD SPREAD
SETTING WIDTH FT METERS SETTING WIDTH FT METERS
10 15 9 2.7 21 15 4.6
15 18 9 2.7 24 15 4.6
20 21 9 2.7 27 15 4.6
25 24 9 2.7 30 15 4.6
GRANULAR MATERIAL
PARTICLE SIZES: Fine/Small  Medium  Large  EXTRA LARGE 
(SAND) (HALF BB) (BB) ROCK SALT
SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD SPREAD
SETTING WIDTH FT METERS SETTING WIDTH FT METERS SETTING WIDTH FT METERS SETTING WIDTH FT METERS
5 3 16 4.9 5 22 6.7 7 28 8.5 8 26 7.9
10 5 16 4.9 6 22 6.7 10 28 8.5 11 26 7.9
15 6 16 4.9 8 22 6.7 12 28 8.5 13 26 7.9
20 7 16 4.9 9 22 6.7 14 28 8.5 14 26 7.9
24 8 16 4.9 11 22 6.7 15 28 8.5 15 26 7.9
29 10 16 4.9 13 22 6.7 17 28 8.5 16 26 7.9
34 11 16 4.9 15 22 6.7 20 28 8.5 17 26 7.9
39 12 16 4.9 16 22 6.7 21 28 8.5 18 26 7.9
44 13 16 4.9 17 22 6.7 23 28 8.5 19 26 7.9
49 14 16 4.9 18 22 6.7 24 28 8.5 21 26 7.9
GRASS SEED
FINE SPREAD SPREAD COARSE SPREAD SPREAD
SETTING WIDTH FT METERS SETTING WIDTH FT METERS
10 7 10 3.0 11 15 4.6
15 9 10 3.0 14 15 4.6
20 11 10 3.0 16 15 4.6
25 13 10 3.0 18 15 4.6
Standard-Output Red Tray
FLEX-SELECT
®
BROADCAST SPREADER SETTING MATRIX
Look for EarthWay® or EV-N-SPRED® models on the bag for settings. If there is none listed, please use the comparison chart below as a guide to estimate your
spreader setting. These settings are approximate and intended as a guide only.
Variations in physical characteristics of material applied, walking speed and surface roughness may require slightly different spreader settings. Due to the above
conditions, the manufacturer makes no warranty as to the uniformity of coverage actually obtained from settings listed.
Grams PER Square
Meter
Grams PER Square
Meter
Grams PER Square
Meter
Grams PER Square
Meter
Grams PER Square
Meter
©2014 Earthway Products, Inc. All rights reserved. EarthWay® EV-N-SPRED®, Flex-Select®, and SPRAY-PRO® are registered trademarks of Earthway Products, Inc.
Use of trademarks or images are prohibited unless approved by Earthway Products, Inc. 1009 Maple Street Bristol, Indiana 46507
Low-Output Black Tray
High-Output Blue Tray
Grams PER Square
Meter
Calibration: Start by ensuring that your spreader calibration is
correct. Make sure the drop holes in the
Standard-Output Tray
are fully open when the Rate Control handle is on #30. If not,
please adjust control rod at the pivot to allow for a full open
hopper holes with the handle at position at #30.
Calibration: Start by ensuring that your spreader calibration is
correct. Make sure the drop holes in the LOW-OUTPUT TRAY
are fully closed when the Rate Control Handle is resting on the
stop #0. If not, please adjust control rod at the pivot to ensure
the shut-off is fully closed with the handle at position at #0.
Move the spreader slightly to confirm the calibration because of
the cam.
Calibration: Start by ensuring that your spreader calibration is
correct. Make sure the drop holes in the
HIGH-OUTPUT TRAY
are fully closed when the Rate Control Handle is resting on the
stop #0. If not, please adjust control rod at the pivot to ensure
the shut-off is fully closed with the handle at position at #0.
Move the spreader slightly to confirm the calibration because of