Altinex AP445-401 - Manual (Page 11)

SPECIAL APPLICATION
400-0422-001 10
7. [STAT]
This command displays the status of the
AP445-401.
Command Format: [STAT] or [STATCi]
Ci = Unit ID (i = # from 0 to 99)
Example 1:
Send the command [STATC1] and receive
feedback showing the status of unit ID 1.
Example 2:
Send the command [STAT] and receive
feedback showing the status of the unit
connected to the RS-232 port regardless of its
unit ID.
8. [STATS]
This command displays the status of the
AP445-401 and saves the settings in memory.
Command Format: [STATS] or [STATCiS]
Example:
Send the command [STATS] and receive
feedback as in the previous example, but in this
case the settings will be saved and recalled
when the same input is selected using the [INR]
command.
9. [CLR]
Reset all parameters to factory defaults.
Command Format: [CLRCi]
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [CLR] to reset the unit to
the factory defaults. After reset, the status will
similar to the following depending on the input
selected:
Input: S-Video Default
Output Resolution: 640x480 Last Saved
Brightness: 24 Last Saved
Contrast: 40 Last Saved
Color: 24 Last Saved
Sharpness: 10 Last Saved
Hue: 24 Last Saved
Audio Volume: 32 Default
VCR Mode Default
NR ON Default
Aspect Ration 4:3 Default
Freeze OFF Default
Front Panel Unlocked Last Saved
10. [IN]
This command selects the input port on the unit
to be used as the source.
Command Format: [INyCi]
y = Input (y = # from 0 to 3)
0 = S-Video
1 = Composite Video
2 = PC Bypass
3 = YPbPr Video
Ci = Unit ID (i = # from 0 to 99)
Example:
Send the command [IN0] to select the S- Video
input.
11. [INR]
This command selects the input port on the unit
to be used as the source and recalls the saved
settings.
Command Format: [INyRCi]
y = Resolution (y = # from 0 to 3)
0 = S-Video
1 = Composite Video
2 = PC Bypass
3 = YPbPr Video
R = Recall image property settings
Ci = Unit ID (i = # from 0 to 99)