Toshiba V.92 - Manual (Page 76)

76 AT Commands
AT command formats
5.375 x 8.375 ver 2.4.0
Example: +MS=V92,1,0,0
This sets the modulation to be V.92 and the speed
negotiations to use automode. This is the modem default.
Example: +MS=V90,0,0,45333
This will limit the maximum speed to 45,333 bps in V.90
mode.
+MS?
This command displays the current +MS command
configuration.
+MS=?
This command displays all supported values for each +MS
command parameter.
<max_rate> The maximum receive rate. If set to 0,
then the max rate will be determined by
the modulation means selected in the
<carrier> and <automode> settings. Zero
is the default. Valid <max_rate> values
are from 300 to 57333. Maximum receive
rates for each valid <carrier> are as
follows, in bits per second:
V92 28000—57333 / steps of 1333
V90 28000—57333 / steps of 1333
V34 2400—33600 / steps of 2400
V32B 4800—19200 / steps of 2400
V32 4800—14400 / steps of 2400
V22bis 2400
V22 2200
Bell212A 1200
V23C
1200
V.21 300
Bell103 300