Hauler Racks C300MINI-1 - Manual

HAULER RACKS, INC. Page 1 of 7 Toll Free: 1-800-843-5445
st 7109 31 Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
WWW.HAULERRACKS.COM
C300 RACK INSTRUCTIONS
P/N C300FULL-1 / C300MINI-1
Package Contents:
PARTS
(2) CROSS BARS
(4) C300 LEGS
(4) C300 HINGE ASSEMBLIES
(4) C300 LOAD SECURE POSTS
HARDWARE
KIT
(8) 3/8”-16 NUTS
(8) 3/8” SPLIT LOCK WASHERS
(8) 3/8”-16 x 2” HEX BOLTS
(20) 5/16”-18 x 1” HEX BOLTS
(20) 5/16”-18 NUTS
(20) 5/16” SPLIT LOCK WASHERS
(8) SPACERS
Before you begin:
Rack fits both straight and angled caps.
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands securing
components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for minor
adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
9/16” Socket or open end wrench
1/2” Socket or open end wrench
3/8” Drill bit and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Level
2x4 Boards