Havener E-40 Edger - Manual (Page 7)

7
3. Move clutch-depth lever located on the top left side of handle, into rear notch of quadrant on
handlebar. (Fig 5).
Move cutter head angling lever located on the left side of frame, to the top notch of quadrant.
4. Remove spark plug wire from spark plug. Check clutch operation by pulling recoil starter rope. If blade
turns when the lever is in top notch, loosen handle bolts and pull back on handles towards operator.
Tighten bolts and check clutch operation again.
5. Reinstall spark plug wire
NOTE: Make sure the blade does not turn when lever is in top notch - disengaged.
Fill Engine With Oil
NOTE:
THERE IS NO OIL IN THE ENGINE CRANKCASE WHEN SHIPPED.
1. Follow instructions in the engine manual for correct grade of oil, oil filling and oil changing
2. Do not mix oil with gasoline.
Figure 5
Figure 6
Angling Lever
Clutch Depth
Lever