Heat Storm HS-1500-OCR - Manual (Page 4)

OpERaTinG inSTRuCTiOn
WaLL MOunTinG
ONly USE SUPPlIED BRACKETS.
1 Ensure the power cable does not touch the reflector of the heater or
hangs into the heated area.
2 Ensure the power cable can reach an indoor socket. Do not twist or
bend the power cable.
3 This heater is IP65 protection, and can be used indoors or outdoors.
If using outdoors and you need a extend socket, the cable and the
socket system must be waterproof.
WARNING:
Do not use the heater directly near a bathtub, a shower or
a swimming pool.
Never plug the appliance into the socket with wet hands
HS-1300-WS, HS-1500-CR
1 Before plugging in heater, turn switch to off position.
2 Firmly plug power cord into a socket.
Turn on /off with heater switch.
HS-1300-TR
1 Turn on heater by firmly plugging in the power cord.
2 Turn off heater by unplugging power cord.
inSTaLLaTiOn
PRECAUTION:
Installation should always
be carried out by a qualified
electrician or a competent person
The energy supply must be done
through a properly grounded
socket.
The heaters should always be
installed horizontally and should
always only use the mounting
brackets or chains provided.
The heater should not be facing
the ceiling or inflammable
substances.
The heater must be installed so
as to prevent that the switches
can be touched from those who
are in the shower.
Do not use the heater directly
near a bathtub, a shower, a
swimming pool.
Ensure that there is no possibility
of inflammable material coming
into contact with the heater, or
lies near the heater.
Heaters should not be installed
in areas where hazardous vapors
may be present. Defined in
BS5345.
The heaters are fitted with safety
guards. These are intended only
to stop large objects from hitting
the emitters. On no account
should the heater be operated
with the guard removed.
WARNING:
Before cleaning, unplug from the power supply and wait a few minutes
to cool down.
This heater contains no moving parts, it needs very little maintenance.
However, when the heater builds up heavy dirt, use a soft cloth to wipe
it off.
HEATING ElEMENT REPlACEMENT
If the heating element malfunctions and needs to be replaced, it should
only be changed by a service agent.
CLEaninG & MainTEnanCE