Advanced Global Technology RR101 - Manual (Page 9)

In
s
ta
lla
ti
o
n
9
Installation
Mounting to the Dashboard or Console
If using the AMPs mounting
holes to fasten the Sportscaster
car mount to your dash or
console, Bolt or screw the
Sportscaster car mount in place
and proceed to step 3. AMPs is
the standard hole spacing used
in most mobile phone mounts.
1. Remove the protective film
from one side of the supplied
double sided tape. Press
firmly to secure the tape to
the bottom of the car mount.
(Figure 1).
2. Remove the protective film
from the remaining side of
the double sided tape. Place
the car mount in the
appropriate location on the
vehicle's dash or console and
press firmly. (Figure 2).
3. Push the Sportscaster into
the car mount until it locks
into place. (Figure 3).
4. Connect the DC Power,
antenna and audio connectors (if required) to the appropriate jacks. (Figure 4).
5. For best reception, place the XM antenna on the vehicle’s metallic roof, at least 6”
from any window or sunroof. It can be placed in the front, middle, or rear of the
roof. (Figure 5).
6. To remove the Sportscaster, push the release tab on the top of the car mount
upward and pull the Sportscaster forward.
If the car is a convertible, you may mount the antenna on the metal trunk lid. It
should be at least 4” from the rear window. Ensure that the antenna and cable
don’t interfere with the opening or closing of the convertible top or the trunk lid.