King Kooker Fire Pit - Manual (Page 10)

10
brAss FIttInG wItH mAnuAl VAlVe
Assembly InstructIons
Locate the brass fitting with manual valve (with hose/regulator attached). Tighten the brass fitting’s
threaded end (with orifice) into the venturi with a torque wrench, up to a torque of 95 to 105 lb./in.
Alternatively, hand tighten securely and then, using a wrench, tighten an additional 1-1 1/2 turns.
The manual valve handle should be positioned upright when installed. See below for pictures of
correct assembly.
Check that the 3/8” female flare swivel end of the hose is fully tightened onto the brass fitting
with an adjustable wrench. The hose to valve connection, as well as all other gas joints, must be
tightened and leak tested (see Leak Test instructions on page 13) before using the appliance.
brass Fitting
manual Valve
Venturi
orifice
lP Gas Hose
Carefully arrange the lava rock evenly on top of the burner and in the bowl. Do not pour or drop lava rocks
onto the burner or bowl as damage could occur to burner ports or bowl.Placement of lava rocks may
need to be adjusted to produce a more realistic looking flame. Arrange lava rocks as needed to produce
a flame that extends upward and toward the center above the appliance. After operation of the appliance,
AlwAys allow time for the lava rocks to cool completely before removing or adjusting lava rocks. neVer
attempt to move lava rocks while the appliance is lit or still hot.
lAVA rocK InstructIons
3/8 Female
Flare swivel