Avaya 580 User Manual

Page 337

Advertising
background image

Document No. 10-300077, Issue 2

12-9

Configuring IP Routing

MAC Format

Select the MAC address format for the interface.

Options include:

• Ethernet V2

• Simple Network Access Protocol (SNAP)

ARP Timeout

Enter the timeout period for Address Resolution Protocol
(ARP) in seconds.The ARP Timeout value is the period of
time the switch will wait for data from a station, if no data
is received, the station is deleted from the ARP Table.

The default is 14,400 seconds (4 hours).

Directed Broadcast

When the IP Directed Broadcast feature is Enabled, it
allows a Network Directed Broadcast (unicast IP address
with the Host ID set to all One's) to be forwarded by the
router on the selected interface. The default is Enable.

IP Routing

Select enable or disable IP routing on the interface.
Options include:

Routing/Mgmt (Default) - Enables you to manage

the switch, from the Command Line Interface (CLI)
or the Web Agent, and configure IP routing for the
switch.

Mgmt Only - Enables you to manage the switch,

however, IP routing is disabled for this interface.

Note:

Do not enable routing protocols on an interface

configured for Mgmt Only since the interface
will act as an end point and will not pass traffic.

Routing Only - IP routing is enabled on the

interface, but you cannot manage the switch through
the interface. Routing Only interfaces do not permit
management traffic destined for local interfaces but
do allow all other traffic including management
traffic destined for interfaces on other switches.

RIP

Enable or disable RIP. The default value is Disable.

OSPF

Enable or disable OSPF. The default value is Disable.

Note:

To Enable OSPF, The Admin State of the IP

interface must be set to down. Enable OSPF and
then set the Admin State to up.

Table 12-1. Add IP Interface Web Page Fields

Parameter

Allows you to...

2 of 3

Advertising
This manual is related to the following products:

882