Avaya 580 - Manual (Page 603)

Document No. 10-300077, Issue 2 20-25
Managing Intelligent Multicasting
CLI Command To configure the LGMP server using the CLI, enter the following command
from Configure mode:
(configure)# set lgmp server <options>
Viewing the LGMP Server Statistics
You can view the LGMP server statistics using either the Web Agent or the
CLI.
Web Agent
Procedure To enable/view the LGMP server using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click LGMP Snooping.
The LGMP Server Configuration Web page is displayed in the content
pane. See
Figure 20-12 .
2. Select Enable from the State field, if it is not already displayed.
3. Click CLEAR to clear the statistics or REFRESH to refresh the
contents of the table.
LGMP Message
Transmission
Statistics • Report - Displays the number of LGMP report
messages transmitted.
• Leave - Displays the number of LGMP leave
messages transmitted.
• End Session - Displays the number of LGMP end
session messages transmitted.
• Router Report - Displays the number of LGMP
router report messages transmitted.
• Router Leave - Displays the number of LGMP
router leave messages transmitted.
Intelligent
Multicast Session
Statistics • Client Ports Added - Displays the number of add
client events generated by LGMP.
• Client Ports Removed - Displays the number of
remove client events generated by LGMP.
• Sessions Removed - Displays the number of
remove session events generated by LGMP.
• Router Ports Added - Displays the number of add
router events generated by LGMP.
• Router Ports Removed - Displays the number of
remove router events generated by LGMP.
Table 20-9. LGMP Server Configuration Web Page Parameters
Parameter Definition
2 of 2