Agilent Technologies Agilent Hard Disk Drive Kit E5070BU - Manual (Page 6)

6 Chapter 2
Option Installation
Introduction
Introduction
This chapter describes the procedure to install Option 018 into the E5070B/E5071B. The
procedure consists of the following items.
• Installation Requirement
• Removing Removable Hard Disk
• Mounting Removable Hard Disk
• Writing System Correction Data of Backup Memory to Removable HDD
• Calibration of the Touch Screen
• Caution for replacing the spare HDD with the original HDD
Update Procedure
Installation Requirement
• TORX Screwdriver T10
Removing Removable Hard Disk
Follow the steps below to remove a removable hard disk.
CAUTION Before removing a hard disk, you must turn off the unit’s power and then disconnect the
power cord from the outlet.
Step 1. Unscrew the four screws that hold the cover panel (1 in Figure 2-1).
Step 2. Remove the panel.
Step 3. Unscrew the four screws that hold the removable hard disk (1 in Figure 2-2).
Step 4. Carefully remove the flat cable (2 in Figure 2-2
*1
) from the removable hard disk. Release
the cable’s connector by pressing the locking hooks at the sides of the connector.
Mounting Removable Hard Disk
Follow the steps below to mount a removable hard disk.
Step 1. Connect the removable hard disk to the flat cable's connector (2 in Figure 2-2).
Step 2. Secure the removable hard disk in place with the four screws (1 in Figure 2-2).
Step 3. Secure the cover panel in place with the four screws (1 in Figure 2-1).
*1.Flat cable with connector outfitted