Ransburg 9060 HV P.S. Electric Motor 80102-21X - Manual (Page 9)

9060 for No. 2 Process Handgun - Safety
CP-13-03.2 4
AREA
Tells where hazards
may occur.
HAZARD
Tells what the hazard is.
SAFEGUARDS
Tells how to avoid the hazard.
Electrical
Equipment High voltage equipment is utilized.
Arcing in areas of flammable or
combustible materials may occur.
Personnel are exposed to high
voltage
during operation and
maintenance.
Protection against inadvertent arc-
ing that may cause a fire or explo-
sion is lost if safety circuits are dis-
abled during operation.
Frequent power supply shut-down
indicates a problem in the system
which requires correction.
An electrical arc can ignite coating
materials and cause a fire or explo-
sion.
The power supply, optional remote control
cabinet, and all other electrical equipment
must be located outside Class I or II, Division
1 and 2 hazardous areas. Refer to NFPA-33
or EN 50176.
Turn the power supply OFF before working on
the equipment.
Test only in areas free of flammable or com-
bustible material.
Testing may require high voltage to be on, but
only as instructed.
Production should never be done with the
safety circuits disabled.
Before turning the high voltage on, make sure
no objects are within the sparking distance.
Toxic Substances Certain material may be harmful if
inhaled, or if there is contact with
the skin. Follow the requirements of the Material Safe-
ty Data Sheet supplied by coating material
manufacturer.
Adequate exhaust must be provided to keep
the air free of accumulations of toxic materi-
als.
Use a mask or respirator whenever there is a
chance of inhaling sprayed materials. The
mask must be compatible with the material
being sprayed and its concentration. Equip-
ment must be as prescribed by an industrial
hygienist or safety expert, and be NIOSH ap-
proved.