Reese 38211 CLASS V SUPER TITAN User Manual
Installation instructions, 20k hitch
Installation Instructions
20K HITCH
Part Numbers:
38211
38123N
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 15/16”
Drill Bits: None
1.
Measure chassis width. If chassis width is under 34.75” then remove shim plates as required (Item 7). To remove shim plates:
remove fasteners (Item 4, 5 & 6). Discard spacer plates (Item 2). Reinstall fasteners and align side brackets. Snug up
fasteners.
2.
Raise hitch into position. Weld hitch to chassis as shown above.
3.
Torque hitch fasteners (Items 4,5 & 6) to:
Tighten 5/8” – 11 Grade 8 fasteners to 190 lb.-ft. (257.6 N*M)
Rev. D
11-12-08
38123N
Sheet 1 of 1
z
2007 Cequent Towing Products
Conical Washer 5/8”
Qty. (16)
5
5
5
5
3/4” Hitch Pin with Lanyard
Qty. (1)
1
1
1
1
Hex Bolt (5/8” – 11 x 2” Grade 8)
Qty. (8)
6
6
6
6
Hitch
Qty. (1)
2
2
2
2
Hex Nut (5/8” – 11 Grade 8)
Qty. (8)
4
4
4
4
Spacer Plate
Qty. (4)
7
7
7
7
Drawbar
Qty. (1)
3
3
3
3
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
20,000 LB (9072 Kg) Max Gross Trailer Weight
3,000 LB (1360.8 Kg.) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Drop position only.
Drawbar Kit:
38124B
Fastener Kit: N/A
Form F206 Rev A 5605
Chassis
Chassis
2
2
2
2
.25
Both Sides
.25
1.25
FRONT OF CHASSIS LOOKING REARWARD
DRIVERS SIDE OF CHASSIS LOOKING AT
THE PASSENGER SIDE
6” – 6.5”
Hitch (38211)
1
1
1
1
6
6
6
6
3
3
3
3
4
4
4
4
5
5
5
5
5
5
5
5
7
7
7
7
Slide hitch
against chassis.
27.0”
20.2”
4.8”
13.7”
10.5”
6.5”
25.4”
11.0”
.25”
Both Sides
Wrap Weld
Around Fillet
1.00”