Reese 45013 TITAN RECEIVER - Manual

INSTALLATION INSTRUCTIONS
Product No.
45013
You can take it with you.
SMALL PARTS
PACKAGE 45276
ELKHART, IN., OAKVILLE, ONT.
TITAN
3/4 TON CHEVY SUBURBAN
& 3/4 TON GMC YUKON XL
TOOLS REQUIRED
3/4” SOCKET
21MM SOCKET
1/2” DRILL
TORQUE WRENCH
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH
(OVER)
1/2” CARRIAGE BOLT
SMALL BOLT PLATE
1/2” FLAT WASHER
1/2” LOCK WASHER
1/2” NUT
5/8” STRUCTURAL WASHER
5/8” LOCK WASHER
M14 BOLT
1. Remove the factory installed 14mm bolt from the bottom of the frame at the rear of the frame.
2. Using the supplied 14mm bolt with the flat washer and a lock washer, bolt the hitch into the holes where the factory
bolt was removed. See the diagram above.
3. Insert The 1/2” carriage bolts with bolt plates down through the next open hole in the frame. Install 1/2” flat washers,
lock washers, and nuts. Snug up the nuts.
4. Using the remaining holes in the hitch brackets as a guide drill 1/2” holes into the frame.
5. Push the pull wire up through the holes drilled into the frame and out through the large hole in the side of the frame.
Slide a bolt plate over the pull wire and screw a 1/2” carriage bolt into the pull wire. Pull the bolt and bolt plate down
through the hole in the frame. Install a 1/2” flat washer, lock washer, and nut on the bolt. Repeat for the last three bolts.
See diagram on the back for more detail on pull wire use.
LARGE BOLT PLATE
For Installation Assistance or Technical Help, Call 1-800-758-0869
45013IN-1APR01B PCN5528 © 2001 REESE PRODUCTS, INC. Litho in USA