Reese 36010 MULTI-FIT MOTORHOME HITCH - Manual

INSTALLATION INSTRUCTIONS Product No.
36010
You can take it with you.
SMALL PARTS
PACKAGE 36875
ELKHART, IN., OAKVILLE, ONT.
MOTOR HOME
TOOLS REQUIRED
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.
3/4" WRENCH
3/4" WRENCH
1/2" DRILL
TORQUE WRENCH
PULL WIRE
IMPORTANT NOTES
Use only Reese supplied or approved bolts, locknuts, and washers to
install this hitch. All "inch" bolts are grade 5 and metric bolts are class
10.9. Nuts are grade B and metric nuts are class 9 unless specified
otherwise. Use toothed washers with bolts over all slots.
Utility hitch bars must insert 5-1/4".
NOTE: This Universal Hitch Receiver will adjust to fit most Motor Homes with frames up to 46" wide outside to outside. Some
modification of existing equipment, such as skid plates, plumbing brackets, auxiliary power unit exhaust pipes or brackets, may
be necessary on some Motor Homes.
THE ADEQUACY OF THE FRAME RAIL EXTENSIONS, AND THEIR ATTACHMENT TO THE FRAME RAILS, TO SUPPORT
THE CUSTOM HITCH RECEIVER IS THE RESPONSIBILITY OF THE INSTALLER.
1. Slip center section into side brackets. Hold assembly up to frame and determine that the hitch bar will clear the bumper; if not,
provide suitable thickness spacers so that it will clear.
2. Position receiver assembly front to rear so that the hitch box is approximately flush with rear of bumper and mark position of rear
edge of side brackets on frame rails. Rear end of side bracket shall not be less than flush with end of frame extension.
Reposition receiver forward if required.
For Installation Assistance or Technical Help, Call 1-800-758-0869
36010IN-09AUG00K © 2000 REESE PRODUCTS, INC. Litho in USA