Reese 36047 PREMIUM RECEIVER - Manual

REESE
INSTALLATION INSTRUCTIONS
Product No.
36047
You can take it with you.
SMALL PARTS
PACKAGE 36392
ELKHART, IN., OAKVILLE, ONT.
DODGE DAKOTA
FORD FLARESIDE WITH ROLLED PAN
TOOLS REQUIRED
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH
9/16" SOCKET
3/4" SOCKET
3/4" WRENCH
TORQUE WRENCH
DODGE DAKOTA
1. Assemble center section and side brackets (flanges out) with six 3/8" knurled bolts pointing outward. Install
six 3/8" lock washers and six 3/8" nuts. Leave nuts slightly loose on bolt at this time.
DAKOTA SHORT BED: If the truck has dual pipe exhaust, it may be necessary to lower the exhaust bracket to
clear the hitch bracket. It may also be necessary to loosen the spare tire and push it forward.
2. FOR 96-PRESENT: Align the brackets with the existing holes in the frame. Install hardware as shown
above.
3. FOR 86-95: Clamp the hitch against the frame. The large holes in the brackets are to clear the rivet on short
bed models. On long bed models, locate the rear hole 1" forward of the end of the frame flange.
1/2” LOCK WASHER
1/2” NUT
3/8” KNURLED BOLT
1/2” BOLT
BOLT PLATE
3/8” LOCK WASHER
3/8” NUT
PLUG
(OVER)
For Installation Assistance or Technical Help, Call 1-800-758-0869
36047IN-1JUN00G PCN5112 © 2000 REESE PRODUCTS, INC. Litho in USA