Reese 37088 PREMIUM RECEIVER - Manual (Page 2)

LIMITED WARRANTY
THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATION AND REQUIREMENTS FOR THE STATE OF NEW YORK AND VESC REGULATION V-5 FOR CONNECTING DEVICES AND
TOWING SYSTEMS. WEIGHT DISTRIBUTING HITCH RATING IS 12000 LB. MAX. GROSS TRAILER WEIGHT AND 1200 LB. MAX. TONGUE WEIGHT. WEIGHT CARRYING HITCH RATING IS
7500 LB MAX GROSS TRAILER WEIGHT AND 750 LB MAX TONGUE WEIGHT. CONSULT VEHICLE OWNERS MANUAL FOR TOWING RECOMMENDATIONS AND LIMITATIONS.
1/2" HEX BOLT
1/2" NUT
1/2" LOCK WASHER
1/2" SERRATED WASHER
BOLT PLATE
1/2" CARRIAGE BOLT
1/2" NUT
1/2" LOCK WASHER
TOOLS REQUIRED
3/4” SOCKET
3/4”
WRENCH
TORQUE WRENCH
1. Hold the hitch up under the frame. Position the holes in the brackets over the rivet heads at the rear of the frame.
2. Insert 1/2” hex head bolts into the plate that extends down from the frame. Install 1/2” lock washers, and 1/2” nuts on all four bolts.
See diagram above. It may be necessary to screw the 1/2” carriage bolt with bolt plate onto the pull wire. Some gas tanks will
limit access to the hole inside the frame. Use the pull wire to pull the bolt into the hole in the frame. Feed the wire through a
more open area in the frame.
2. Install 1/2” carriage bolts with bolt plates down through the holes in the frame beside the spring hangers. Install 1/2” serrated
washers, 1/2” lock washers, and 1/2” nuts on the bolts. See diagram above.
4. Torque 1/2” nuts to 70 ft*lbs.
INSTALLATIONS FOR:
FONTAINE CONVERSIONS
1/2" PULL
WIRE 55392
Towing Products warrants its Hitches, custom Hitch Receivers, and Sway Controls from date of purchase against defects in material and
workmanship under normal use and service, ordinary wear excepted, for the ownership life of the original consumer purchaser. Towing Products
will replace FREE OF CHARGE any part which proves defective in material or workmanship when presented to any Towing Products dealer,
Towing Products Warehouse, or returned to factory, TRANSPORTATION CHARGES PREPAID, at the address below. THIS WARRANTY IS
LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR
REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED. Some states do
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage
to the Hitch, Custom Hitch receiver or Sway Control as a result of misuse, abuse, neglect, accident, improper installation, or any use violative of
instructions furnished by Towing Products, WILL VOID THE WARRANTY.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem
with warranty service or performance, you may be able to go to a small claims court, a state court, or a federal district court.
Towing Products
PO Box 8102
47774 Anchor Ct.
Plymouth, MI 48170 Towing Products
2351 Winston Park Drive
Oakville, Ontario
Canada L6H6R7
N37088-12-16-02 EWO3289 © 2002 TOWING PRODUCTS Litho in USA