Reese 44590 PROFESSIONAL RECEIVER - Manual

Installation Instructions
BMW X5
Note: Fascia trim required
Part Numbers:
87455
75600
44590
Hitch Shown In Proper Position
Equipment Required: Utility Knife, Small center punch, 5/32” Rivet tool
Wrenches: 10mm, 18mm Deep Socket
Fastener Kit: 75600F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 6000 (2724 Kg) 600 (272 Kg)
Weight Carrying
Ball Mount
6000 (2724 Kg) 600 (272 Kg)
Wiring Access Location: SUV3 & SUV4
Bulkhead
Fascia
Impact bumper
Existing flange nuts. (8)
Bulkhead
Figure 1.
Impact bar
1. Remove rear bumper fascia. Disconnect back-up sensor wiring if present. (Not shown)
a. Remove 2 (3*) plastic pop rivets (each side) from the plastic wheel well molding (See Figure 2). Rivets can not be re-used.
Replacements supplied. To remove rivet, insert small center punch or drill bit into center to push pin through.
b. Gently pull back wheel well molding to locate and remove fascia screws (See Figure 4). One each side.
c. Remove 6 screws from bottom of fascia.
d. Remove reflectors, (Reflector can be removed by releasing the clip that holds it in place, access under the bumper) (Figure 2).
e. Remove the screws behind the reflectors ( See Figure 3).
f*. Open bottom tailgate at a 45°angle and notice the tabs retaining the fascia lip.
g*. Taillights may have to be removed if retaining tabs under light can’t be popped loose.
h. Gently pull the fascia from the wheel wells outwards and rearward from the rear of the vehicle.
2. Remove impact bar using 18mm deep socket. Lower tailgate to access upper mounting fasteners.
3. Raise hitch into position.
4. Re-install impact bar over hitch brackets, and re-install existing flange nuts (See Figure 1). Center hitch on vehicle.
5. Tighten all fasteners to torque specifications. Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft. (88 N*M)
6. Trim fascia using utility knife. Locate bottom center of the fascia mark 4” wide side to side x 2” high. (overall 8” wide X 2” high)
(See Figure 5). Fascia trim required. Obtain vehicle owners approval before cutting
7. Reattach bumper fascia. Reconnect wiring. (Not shown)
Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft. (88 N*M)
z 2007, 2008, 2012 Cequent Performance Products Sheet 1 of 6 75600N 5-22-12 Rev. C
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05
Fascia trim required. Obtain vehicle
owners approval before cutting
Figure 1.
1 1 1 1 Qty. (6) Plastic rivet (Not shown)
* (2011 – Present models)