Reese 44636 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Ford Flex
Ford Flex EcoBoost
Lincoln MKT
Part Numbers:
75679
87571
44636
78189
U-Haul
Fascia
Hitch Shown In Proper Position
Equipment Required: Lubricant or Soapy water
Fastener Kit: 75679F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: SUV1, SUV2
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 4000 (1816 Kg.) 400 (182 Kg.)
Weight Carrying
Ball Mount
4000 (1816 Kg.) 400 (182 Kg.)
Wrenches: 18mm, 19mm, 6” Ratchet
Extension ( Ford Flex)
Exhaust hanger bracket
Vehicle Frame
Rubber Exhaust Hanger
1
2
Existing
Weldnuts
Spray some lubricant on the
rubber exhaust hangers and then
use a screwdriver or pry bar to
Note: On the Lincoln MKT and Ford Flex EcoBoost model have duel exhaust, repeat instruction listed below to the passenger side
exhaust.
1. Lower exhaust by removing two (2) bolts which attach exhaust hanger bracket to driver’s side frame rail. Return to owner.
Note: Re-attachment of exhaust hanger bracket may be made easier by removing rubber exhaust hanger from hanger bracket
1 Qty. (4) Hex Bolt M12 x 1.75 x 40mm CL8.8 2 Qty. (4) Conical Toothed Washers ½”
Fasteners Typical Both Sides of Vehicle
use a screwdriver or pry bar to
remove all of the rubber hangers.
Support the system while you
remove all of the hangers
Note: Re attachment of exhaust hanger bracket may be made easier by removing rubber exhaust hanger from hanger bracket.
2. Detach the rubber isolator from the front exhaust hanger located forward of muffler, just behind rear axle. Be careful not to allow
muffler to fall under their own weight. Spraying a lubricant on the metal hanger rod and the rubber isolator helps removal.
3. Rotate the hitch into position over the exhaust and align the slots to the existing weld nuts. Reattach exhaust hanger bracket to
underside of hitch bracket (as shown). On models with dual exhaust, do this on both sides of vehicle. Install fasteners as shown
above.
4. Tighten all fasteners to the required torque specification.
5. Raise exhaust back into position and reattach to rubber isolators. Spraying a lubricant or soapy water on the metal hanger rod
and the rubber isolator helps.
z 2009, 2010 Cequent Performance Products Sheet 1 of 3 75679N 4-7-10 Rev. B
Tighten all M12 x 1.75 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Form: F205 Rev A 5-6-05