Reese 44026 PROFESSIONAL RECEIVER User Manual
Installation instructions, All ford pickup, Series 51
Installation Instructions
All Ford Pickup
(Except Ranger & Flare Side Pickup with
Fiberglass Rear Valence Panel)
Part Numbers:
44026
51009
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4, 7/8
Drill Bits: 1/2”
Frame rail
Note: Due to vehicle variation, it may be necessary to adjust Step Bumper upward.
1.
Remove all but a thin layer of undercoating from attaching surfaces.
2.
Position hitch over rivets on both frame rails, making sure the hitch is centered.
Note: Make sure rearmost attachment will allow block to sit flat on inside of frame rail, and pushed up against the crossmember.
3. Using the hitch as a template, drill three (3) 1/2” holes into the bottom of each frame rail.
4. Install all fasteners as shown above, placing blocks inside vehicle frame as shown.
Rev. A
6-27-06
N51009
Sheet 1 of 1
z
2001, 2002, 2006 Cequent Towing Products
Flat Washer 1/2
Qty. (6)
3
Hex Nut 1/2-13
Qty. (6)
5
Block
Qty. (6)
2
Lock Washer 1/2
Qty. (6)
4
Hex Bolt 1/2-13 X 1.75
Qty. (6)
1
Tighten all 1/2-13 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51009-051
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg)
5000 (2270 Kg)
Weight Carrying
Ball Mount
1000 (454 Kg)
10,000 (4540 Kg)
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PC1, PC2
Vehicle Crossmember
2
1
4
3
5
Step Bumper
Fasteners typical both sides.
SERIES 51®
Form: F205 Rev A 5-6-05