Reese 44557 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Jeep Wrangler
Jeep Wrangler Unlimited
Part Numbers:
75515
44557
87424
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4”
Drill Bits: None
1
Crossmember
Rev. A 8-16-06 75515N Sheet 1 of 3 z 2006 Cequent Towing Products
Conical Washer Qty. (4) 2 Hex Bolt 1/2-13 X 4.50 Qty. (4) 1
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75515F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
350 (159 Kg) 3500 (1589 Kg)
Weight Carrying
Ball Mount
400 (182 Kg) 4000 (1816 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: TBA
2
Crossmember
Bumper
Spare tire
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch installation.
1.
Lower exhaust. (If required)
2. Raise hitch into position.
3. Install fasteners as shown above.
4. Reinstall the vehicle exhaust. (If required)
Form: F205 Rev A 5-6-05