Reese 33095 PROFESSIONAL RECEIVER - Manual

Bumper
Structure
Fascia
Pins
FIGURE 1
Installation Instructions
Jeep Grand Cherokee
Jeep Commander
Part Numbers:
33095
75338
87752
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch
installation. Installation time will increase from 20 Min. to 90 Min.
1. Lower the spare tire.
2. Remove two plastic pins that hold bumper fascia onto bumper structure as shown in Figure 1. (If OEM tow hook is present: Remove fascia,
plastic bumper support and tow hook)
3. Gently pull fascia rearward about one inch and raise the hitch into position as shown in Figure 1.
4. If there is excessive gap between the vertical surfaces of the hitch and the bumper structures, flat washers should be used as shims. They can
be held in place using cellophane tape. See Figure 2.
5. Secure hitch with fasteners. Fascia may contact the back of the hitch. (Reinstall fascia and plastic bumper support if removed in Step 2.)
6. Replace plastic pins in bumper fascia.
7. Raise the spare tire into storage position.
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
©2005, 2006, 2007, 2008, 2011 Cequent Performance Products Sheet 1 of 3 75338N 9-27-11 Rev. F
j
Qty. (4) Hex Bolt, 1/2- 13 x 4” l
Qty. (8) Flat Washer, 1/2”
k
Qty. (4) Conical Washer, 1/2”
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Equipment Required:
Wrenches: 3/4”
Fastener Kit: 75338N or 87752N
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 7500 (3405 Kg) 750 (341 Kg)
Weight Carrying
Ball Mount
5000 (2270 Kg) 750 (341 Kg)
Wiring Access Location: SUV1, SUV2
FIGURE 2
Hitch Shown In Proper Position
Bumper
Structure
Bumper
Fascia
78259 UHAUL