Reese 44704 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Mercedes-Benz ML350*
(will not fit 2012 & newer ML350 DEISEL.)
Part Numbers:
44704
75874
87653
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 10mm, 3/4
Drill Bits: NONE
1. Support the exhaust and remove exhaust from hangers so exhaust can be lowered out of the way.
2. Remove the plastic fascia brackets (return to owner) shown in Figure 1. and the exhaust heat shield cover hardware, so shield can move freely
above the exhaust.
3. Remove the four (2 per side) lower M10 nuts from the bumper brackets (do not discard).
4. Raise the hitch into position with side brackets installed on the bumper bracket bolts and loosely reinstall the M10 nuts removed in step 4.
5. Raise the forward end of the hitch to the cross member under the car. Place bolt plate with 1/2” bolts and washers installed through existing
vehicle cross member holes and into matching hitch bracket.
6. Tighten from 10mm bolts to torque specs below and reinstall the heat shield. (note heat shield may need to bend a little to be reinstalled
around hitch.)
7. Using Zip ties provided. Zip tie hitch to the fascia where the removed brackets where located.
Tighten all M10 fasteners with torque wrench to 38 Lb.-Ft. (52 N-M)
© 2013 Cequent Performance Products, Inc Sheet 1 of 3 75874N 10-17-13 Rev. A

Qty. (2) 1/2 -13 x 4.00 Bolt

Qty. (5) Zip Ties

Qty. (2) 1/2-13 Hex Nut

Qty. (2) 1/2 Conical Washer
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (101 N-M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75874F
Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 4000 (1 816 Kg) 525 (238 Kg)
Weight Carrying
Ball Mount
3500 (1 589 Kg) 525 (238 Kg)
Wiring Access Location: SUV3, SUV4
Bumper Bracket
Figure 1.
Remove in
step 2.
*
Will not fit models equipped with Air
Suspension Package
Existing Nuts
3 2
1
Sub Frame
Fascia
Printed in Mexico