Reese 44690 PROFESSIONAL RECEIVER - Manual (Page 2)

Installation Instructions Part Numbers:
View of Clamp Brackets in place
Looking forward on vehicle showing bolts and lock washers in place. Make
sure brackets are vertical inside of cross member depression and then torque
to 75ft. lbs. before raising hitch up under vehicle.
Mercedes GLK350
All Models including 4-Matic & RWD
Passenger’ side
of vehicle
Vehicle
Forward
Offset hole
towards
passenger’s side
Hitch forward
attachment hole.
Insert 5/8” thick
block vertically
between hitch bar 87593
75774, 87636
44690, 78303
U-Haul
z 2013 Cequent Performance Products, Inc. – Printed in Mexico Sheet 2 of 6 75774N 5-31-13 Rev. B
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05
between hitch bar
and this hole.
View of bumper fascia tab
Bend up or remove before installing hitch.
Bend up or
remove this tab
87593