Reese 44603 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Dodge Ram
Part Numbers:
75662, 87530,
44603, 41895
(U-Haul)
Hitch Shown In Proper Position
Set the ¾” hex nut
into the cut out on
the strap, to assist
installation.
Wrenches: 3/4” & 1-1/8”
1. Removal of the spare tire can make installation easier, however, removal not necessary.
2. Remove trailer ball cover cap in center of bumper.
3. Install the conical washer and 3/4” hex bolt into the trailer hitch ball attachment hole in vehicle bumper.
4. Raise hitch into position.
5. Slide the 3/4” hex nut into position under rear attachment (hand tighten only until all fasteners are installed).
6. Feed pull wire through cross member. Attach spacer (Item 5), attach to carriage bolt (Item 4), and pull fasteners through vehicle
cross tube and into position as shown.
7. Loosely install conical washers (Item 6) and nuts (Item 7) onto carriage bolts.
8. Torque all fasteners to specifications.
.
z 2009 Cequent Performance Products Sheet 1 of 3 75662N 10-26-09 Rev. E
j Qty.
(1)
Hex bolt 3/4-10 X 3.5 GR5
n Qty.
(2)
Spacer
k Qty.
(1)
Conical washer ¾” o Qty.
(2)
Conical washer ½”
l Qty.
(1)
Hex nut 3/4-10
p Qty.
(2)
Hex nut ½-13
m Qty.
(2)
Carriage bolt ½-13 GR8
q Qty.
(2)
Pull wire
Tighten all ¾-10 GR5 fasteners with torque wrench to 260 Lb.-Ft. (353 N*M)
Tighten all ½-13 GR8 fasteners with torque wrench to 110 Lb.-Ft. (149 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
`
Fastener Kit: 75662F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 10,000 (4540 Kg) 1000 (454 Kg)
Weight Carrying
Ball Mount
6000 (2724 Kg) 600 (272 Kg)
Wiring Access Location: PU3
Form: F205 Rev A 5-6-05
Step bumper required:
Hitch design for Step bumper.
j
k
l
op
n
m
Removal of the spare tire can make
installation easier, however,
removal not necessary.
Equipment Required:
l
Feed pull wire
Crossmember
q