Reese 33090 PROFESSIONAL RECEIVER - Manual

Frame Rail
Fascia
Installation Instructions
Toyota Tacoma
(Does Not Fit Toyota X-Runner)
Part Numbers:
33090
75236
87581
Do Not Exceed Lower of Towing Vehicle
Existing Weld Nuts
k
Hitch Shown In Proper Position
Fascia Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 5500 550
Weight Carrying
Ball Mount
5000 500
Wiring Access Location: PU3, PU4
Frame
Bumper
Structure
Existing Weld Nuts
5 Places
Both Sides
Bumper Bracket
Both Sides Equipment Required: Torque Wrench
Wrenches: 10mm, 17mm, 19mm
Drill Bits: NONE
Fastener Kit: 75236F
Existing M12
Hex Washer Bolts
Both Sides
Figure 1
Remove
Loosen
Remove
1. CAUTION: SUPPORT THE BUMPER STRUCTURE TO KEEP IT FROM SWINGING OUT OF POSITION DURING HITCH
INSTALLATION.
1 Qty. (4) Conical Washer, 1/2” 3 Qty. (4) Spacer
2 Qty. (4) Hex Bolt, M12 x 40 x 1.25
Figure 2
2. Referring to Figure 2, remove two (2) of the existing M12 hex washer bolts from the bumper bracket as shown, and loosen the
other three (3) bolts. Do this on both sides.
z 2005, 2010 Cequent Performance Products Sheet 1 of 6 75236N 8-25-10 Rev. F
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.