Reese 44587 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Toyota Highlander
Toyota Highlander Hybrid
Will not fit with full size 19” spare.
Part Numbers:
44587
75586
87452
Hitch Shown In Proper Position
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 5000 Lb. (2270 Kg) 500 Lb. (227 Kg)
Weight Carrying
Ball Mount
5000 Lb. (2270 Kg) 500 Lb. (227 Kg)
Fascia
Equipment Required: Small Flat Head Screwdriver, Phillips head
Screwdriver
Wrenches: 10mm, 14mm, 17mm
Drill Bits: None
Fastener Kit: 75586F
Wiring Access Location: SUV3, SUV4
Existing weldnuts in
Vehicle frame
1
2
1 Qty. (6) Hex Bolt – M10 x 1.25 x 30mm CL10.9 2 Qty. (6) Conical Toothed Washer – 3/8”
Fasteners typical
Both sides of Vehicle 12
1. Remove plastic appearance panels which cover driver’s and passenger’s side frame rails. Return appearance panels and
fasteners to vehicle owner.
2. Remove tow hooks from each frame rail and return hooks and fasteners to vehicle owner.
3. Raise hitch into position and install fasteners as shown.
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Tighten all M10 x 1 25 CL10 9 fasteners with torque wrench to 42 Lb Ft (57 N*M)
z 2007, 2009, 2011 Cequent Performance Products Sheet 1 of 3 75586N 4-21-11 Rev. E
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle
and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Form: F205 Rev A 5-6-05