Reese 21141 ADJUSTABLE BALL MOUNT - Manual

For Installation Assistance or Technical Help, See our Web Site at
www.reeseprod.com or Call 800-632-3290
INSTALLATION INSTRUCTIONS
Product No.
21141
You can take it with you.
SMALL PARTS
PACKAGE 21148 PLYMOUTH, MI
(OVER)
21141IN Rev B 4-6-06 PCN8576 © 2001, 2006 Cequent Towing Products
Adjustable Utility Ball Mount
1. HITCH BALL SELECTION - Ball diameter must match trailer coupler size. The three most common sizes are 1-
7/8", 2", and 2-5/16". Select ball with 1" threaded shank that is V-5 rated equal to or greater than trailer gross
vehicle weight rating (GVWR).
WARNING: Raised balls usually have reduced load ratings. Ball rating must equal or exceed trailer GVWR.
2. ATTACH BALL TO MOUNT - REESE standard height hitch balls with 1" shank are supplied with lockwashers and
nuts. Always use a lockwasher and place washer next to nut. Unless otherwise specified by ball manufacturer
torque ball nut to 250 ft/lbs. for 1" nut after mount is attached to hitch.
3. ADJUST BALL HEIGHT - Insert hitch bar into hitch box and install pull pin. Place mount onto hitch bar; move up or
down for proper height. The holes are 1.50" apart. Hitch bar may be used either up or down.
4. Always offset ball mount towards tongue of trailer. Never towards tow vehicle.
SHANK ASSEMBLY
BALL MOUNT