Reese 30154 MOUNTING KIT ADAPTER - Manual (Page 2)

© 2013 Cequent Performance Products, Inc. Printed in Mexico 30154N 06-24-13 Rev. A
1. SYSTEM ASSEMBLY P. 2 2. SYSTEM ADJUSTMENT P. 3
3. INSTALLATION P. 4 4. REMOVAL P. 4
5. BEFORE EACH TRIP/LUBRICATION P. 4 6. LIMITED LIFETIME WARRANTY P. 5
WARNING:
Failure to follow all of these instructions may result in death or serious injury
INDEX
SYSTEM ASSEMBLY
REQUIRED TOOLS
• 1 ½” CLOSED END WRENCH
• NEEDLE NOSE PLYERS
• RUBBER MALLET
TEE PIN AND BUSHING ASSEMBLY
The anchor bushing is passed through the fore-aft tube, aligning the flat edge in the tube with the flats in the bushing. Then the 1”
jam nut is threaded on to the anchor bushing to a point where there is no more vertical motion allowable and then another quarter
turn of the nut. The Tee pin anchor is then passed through the anchor bushing and the anchor handle is threaded on to the tee pin.
It is important to note both larger, Heave Duty tee pins are in the rear of the adapter, the rear of the adapter has a REESE
label facing outward.
Once the tee pin anchor is set at the correct height a cotter pin is passed through the slot in the anchor handle and the hole in the
tee pin anchor. Finally the end cap is installed with the ribs being inserted into the fore-aft tube.
END CAP
ANCHOR BUSHING
1” JAM NUT
TEE PIN ANCHOR
FIG 1
ANCHOR HANDLE
COTTER PIN
SHEET 2 OF 5
FIG 2a
HD TEE PIN ANCHOR
(MATCHING SCALE)
FIG 2b
TEE PIN ANCHOR
(MATCHING SCALE)
FORE-AFT TUBE