Reese 30033 22K FIFTH WHEEL - Manual (Page 5)

7. Lubricate yokes (37) in head support with heavy oil or chassis grease.
8. Install outer tubular handle (35) over solid inner handle (17) and pin together with cotter pin (34). Bend cotter pin to
hold in place. Check that latch bolt (19) is snug. Do not over tighten (latch (18) must be able to move with
firm hand effort). Check to see that all retainer rings (16) are in place.
BEFORE EACH TRIP:
9. Place pivot assembly (29) into yokes in head support (27) and secure with two short pull pins (23). Install spring
cotter pins (24) into grooves in pull pins.
10. Install head assembly (26) into pivot assembly (29) and secure with two short pull pins (23). Install spring
cotter pins (24) into grooves in pull pins.
1. Lubricate skid plate surface of the hitch (see figure on cover of Manual) with automotive type chassis grease or use a
plastic lube plate to provide a lubricated surface. Use engine oil to lubricate pivot points of moving parts within the hitch.
2. Plastic lube plates (Reese No. 74295) can be used to avoid messy grease. The plastic lube plate must not exceed 3/16 of
an inch in thickness to ensure hitch will operate properly. Lube plates must be 10 inches in diameter or larger to properly
distribute king pin weight.
3. Before each trip or maneuver, operate the handle and check that the jaws open and close freely.
4. See that all hitch pull pins (# 11 on Fig. 19) are in place and the spring retaining pins (#12 on Fig. 19) are installed.
IMPORTANT: YOU ARE RESPONSIBLE FOR SAFE HITCHING AND UNHITCHING OPERATIONS. DO NOT RELY ON
OTHERS TO PERFORM YOUR DUTIES YOU MUST PERSONALLY MAKE SURE THE FOLLOWING
HITCHING PROCEDURE:
OTHERS TO PERFORM YOUR DUTIES. YOU MUST PERSONALLY MAKE SURE THE FOLLOWING
STEPS ARE PERFORMED IN THE FOLLOWING ORDER!
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN DEATH OR SERIOUS INJURY.
1. Place blocks (sometimes called “chocks”) firmly against front and rear of each trailer wheel to prevent any possible
forward or rearward motion. DO NOT REMOVE BLOCKS UNTIL EACH OF THE FOLLOWING STEPS AND THE
PULL TEST HAVE BEEN COMPLETED. Lower tailgate if necessary.
2. Using trailer jacks, adjust trailer height following the directions in the trailer manual so that bottom of trailer pin box (“A” in
Fig. 8) is ½ to 1 inch below skid plate (See “B” in Fig. 8). During the hitching maneuver, the bottom of the trailer pin box
should come in contact with skid plate ramp (“C” in Fig. 8).
Hitch Skid Plate (B)
Fig. 8
CORRECT
Bottom of Pin Box (A)
1/2 To 1 Inch Below
Hitch Skid Plate (B)
Skid Plate Ramp (C)
Bottom of Pin Box (A)
Bottom of Pin
Box Above
Hitch Skid Plate
Fig. 9
WRONG
30033IN-OCT 28,2008 F PCN11465 ©2005 CEQUENT TOWING PRODUCTS, INC LITHO IN USA
5
CORRECT
WARNING:
Failure to follow this instruction may result in king pin being too high and coming to rest on top of closed jaws or
not completely inside jaws. (See Fig. 9). This could result in trailer separating from hitch. Trailer separation may
result in death or serious injury if anyone is under the trailer or between truck and trailer when separation occurs.